WATER BASE SPRAY GRAIN (WBSG) - This water base product is a one part spray grain. Used with a Pre Val sprayer this grain creates a fine to medium grain depending on the application rate. Once dried it can be sanded for desired texture. This product works excellent as a blending agent to hide any flaws left in your repair.
CHIP GUARD (3980) - This is an aerosol of texture spray. Protects vulnerable lower panels from chipping and metal corrosion,. Excellent adhesion and extra tough film for ultimate protection. Spray pattern may be varied to match various factory textures.
FLEXIBLE PRIMER SURFACER (3000) - Apply Primer Surfacer on repaired areas, let dry, then sand down till you achieve desired texture. You can build up layers to improve your texture.
FLEX-TEX (3800) - A unique blend of flexible materials designed to be used for retexturing repaired areas on plastics, dashes, vinyls, bumpers and armrests. Apply Flex-Tex on repaired areas, let dry, then sand down till you achieve desired texture.
PLASTIC CLONE (PC) - A two-step process used to duplicate the same grain impression you will need to finish your repair. When you are read to grain, spray a light tack coat over the entire area you are graining. Wait about fifteen to twenty seconds, then spray a wet coat. After making a graining pad with the same texture you will spray your activator on the pad and on the repair area. Then press the pad over the repaired area and hold for about thirty seconds. Now dab off the excess moisture to see the grain. Repeat until desired texture is achieved.
MIRACLE DASH TEXURE "A" (MDTA) - This is the first of a two part process. Spray on repaired area. The heavier the amount sprayed will create a deeper grain. Let dry for 10-30 seconds depending on temperature, then apply....
MIRACLE DASH TEXURE "B" (MDTB) - This is the second of a two part process. After the application of (MDTA) spray this over the repaired area and allow the chemical reaction of both products to create your texture. The heavier the amount sprayed will create a wider grain.
TEXTURE COATING (3985) - This aerosol of texture spray duplicates the original finish on urethane bumpers, instrument panels, dashes, consoles and other textured plastic and vinyl parts. No priming required.
LEATHER CLONE (LC) - A two-step process is used to duplicate the same grain impression you will need to finish your repair. When you are ready to grain, spray a light tack coat over the entire area you are graining, wait about fifteen to twenty seconds then spray a wet coat. Make a graining pad with the same texture. Spray your activator on the pad and on the repaired area, then press the pad over the repair area and hold for about thirty seconds. Now dab off the excess moisture to see the grain. Repeat until you achieve the desired texture.
GRAINING COMPOUND CATALYST (GCC) - This is the catalyst for the graining compound. Use six to eight drops of the catalyst to one ounce of compound.
GRAINING PAD SET (GP-S) - We have compiled a set of fifteen graining pads with the most popular grains embedded in them. These pads have a vinyl backing to help you identify the pattern on the grain and to protect your hands from the heat.
GRAINING PAPERS SET (GPS-6) - A set of 6 different thin papers (3" x 8") with grains to be used with our heat iron to reproduce your grain.