|
|
Table of Cyanocrylate Adhesives
BOND/CA (PT-08) | FLEX/BOND
(PT-32) | ZAP-A-GAP (PT-02) | SLO-ZAP
(PT-20) | POWER GEL (SPG) | BOND
KICKER (PT-15) | DEBONDER (PT-16)
- BOND/CA (PT-08)
A very thin cyanoacrylate. Use this instant curing adhesive
for tacking operations on plastic and urethane bumper repairs.
It is not recommended for cloth or leather since the thinner
adhesive will absorb into the material and will result in
a large, noticeable hard area. On dash repairs it is useful
for cementing the edges of broken PVC. This adhesive is used
with Micro Balloons & Plastic Powder.
- FLEX/BOND (PT-32)
A gap filling, more flexible adhesive which retains texture
and bonds more porous surfaces. Most used of all the adhesives,
can bond cloth seams together by applying a small amount to
both surfaces (in small increments), gather together and hold
with lock tweezers, then use accelerator. Create texture on
hard plastics by dabbing Flex-Bond with a piece of foam, accelerating,
then scuffing with 320-400 grit sandpaper. Do not use on large
areas as cracking will occur on flexible substrates. Flex-Bond
cures slower which allows repositioning of mating surfaces.
- ZAP-A-GAP (PT-02)
This is a "non surface sensitive" adhesive, which
means it will bond to surfaces other adhesives will not. It
allows you to bond vinyl, leather and plastics even when the
surface is contaminated with oils, silicones and mold release
agents. The medium viscosity allows you time to position your
components before it cures. Try using on vinyl welting to
bond back in place.
- SLO-ZAP (PT-20)
This is a high viscosity adhesive with maximum gap filling
qualities. It will have the slowest curing time of all the
adhesives.
- POWER GEL (SPG)
The thickest of all the adhesives. Use where maximum filling
is required or where an instant heavy texture is needed. Power
Gel is so strong that it can fix rips in vinyl in areas where
flexibility is not critical. Can be used on armrests, dashes
and console covers.
- BOND KICKER (PT-15)
Used to accelerate drying time of all our cyanoacrylate adhesives.
Apply with a brush, sprayer or dropper. Apply the kicker first
to vertical surfaces to help stop run off. When using Power
Gel apply to both top and bottom to ensure curing all the
way through.
- DEBONDER (PT-16)
Removes cured cyanoacrylates from skin and other surfaces.
Apply and let soak into adhesive before wiping with a clean
rag.
Note: Keep all adhesives at room temperature
or lower to extend shelf life.
|