LEATHER FILL (LF) - A water based compound
used for small cracks and blemishes. Air cures and is easy to
sand.
LEATHER CRACK FILL (LCF) - A solvent based
compound used for repairing surface cracks that air drys and
sands easily.
LEATHER CREAM FILL (LCR) - A water based
compound used to for a smooth skin finish over the repaired
area. Apply with a paper towel quickly and let air dry. This
will provide a final base from which to texture and color.
LEATHER PRIMER (LP) - This is designed
to help adhesion on other compounds if you are having problems
with the color not adhering.
LEATHER SMELL CONDITIONER (LSC) - A basic
leather conditioner that contains a high leather smell.
LEATHER SOFT FILL (LSF) - Use to fill in
any pinholes or minor imperfections. Just a quick swipe with
the pallette knife will do, much like using spot putty. Let
air dry.
DEEP LEATHER FILL (DLF) - This water base
leather compound is used for deeper cracks. It is an air cured
compound that needs to be layered, alloying to dry in between
coats. Use the other compounds as needed (LF-LSF-LCR) to finish
the repair.
LEATHER ADHESIVE (LA) - This should be
wiped into any exposed leather fibers such as in frayed areas,
slices part way through or where there may be a series of digs
in the leather that can be brushed back and laid back down.
Do not leave Leather Adhesive on the surface to the original
finish. Allow to air dry. Also used as adhesive to secure a
subpatch.
LEATHER CLONE (LC) - A two-step process
is used to duplicate the same grain impression you will need
to finish your repair. When you are ready to grain, spray a
light tack coat over the entire area you are graining, wait
about fifteen to twenty seconds then spray a wet coat. Make
a graining pad with the same texture. Spray your activator on
the pad and on the repaired area, then press the pad over the
repair area and hold for about thirty seconds. Now dab off the
excess moisture to see the grain. Repeat until you achieve the
desired texture.
FLEXIBLE URE-WELD (39406) - Two part base
compound used to repair large damaged areas. After Ure-Weld
dries sand smooth and finish repair with the other leather products
as needed.
HEAT CURED LEATHER COMPOUND (LRC-40) -
A low temperature heat cured compound used in repairing leather
the same way vinyl repair compound is used. You can also use
the other leather products to finish off the repair as needed.
LEATHER PENETRATE DYE (LD) - Penetrate
dye is used with a clean lint free cloth and wiped on the leather.
It is used for complete color changes. An example is if you
are dying from white to black. When you apply the dye, it will
penetrate into the leather and change the color almost instantly,
then spray your color coat over the top.